TA Instruments TGA 2950 Operator's Manual page 243

Figure D.3
Installing the EGA Mounting
Screws, Spacers, and Cleats
TA I TGA 2950
NSTRUMENTS
TGA 2950 EGA Furnace Option
Spacer
Cleat
Cleat
Short Screw
Long Screw
8. Tighten the upper two mounting screws
fully, then loosen each of them no more than
one full turn, so that the flat sides of the
cleats are aligned vertically as shown in
Figure D.4.
Now tighten the lower two mounting screws
fully, then loosen each of them two full
turns, plus a fraction of a turn, so that the
flat sides of the cleats are aligned vertically
as shown in Figure D.4.
D–9