Table of Contents
Advertisement
RESET PROCEDURE
IMPORTANT
You must reset the desk prior to use:
To reset you must push and hold the DOWN button on the Hand Remote (7) until the table lift reaches its
lowest point. Release the DOWN button. Press and hold the DOWN button again until the LED display
shows "RST". If you are not using an LED hand remote hold it for about 10 seconds. Release the DOWN
button. Finally Press and hold the DOWN button once more until the table lift lowers, slightly rises then
stops. Release the DOWN button and your table lift is now ready to use.
OPERATIONAL PROCEDURE
Once your table lift is installed it is simple to operate. Just use the wired remote for full up/down motion
control. Use the up button to raise the table lift and use the down button to lower it.
You can preset up to 4 positions by following this simple procedure: Use the up/down buttons on the
remote to find your desired height(s), then press "M" followed by a number 1-4., then wait a few seconds
until the height is displayed again. To move to the set position, hold the number button.
Once a preset button is pushed, the desk will move to the programmed height. Make sure no obstacles
are in the table lifts path and that it is not touching any walls.
HOW TO ORDER
1.800.676.6123
|
sales@progressiveautomations.com
|
www.progressiveautomations.com
Page 6 of 7
Advertisement
Table of Contents
