Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
STEP 1
Attach the 120° Frames (7,8) to one of the Legs (3) as
shown in the picture below. Line up the holes on the Leg
with the holes on the Frames.
Use the supplied Allen Wrench to insert four M6x10
Machine Screws (10) through the holes on the Frame
(7,8) going into the Leg (1). Rotate each screw just a few
turns until all four are inserted, then tighten them.
STEP 2
Place one of the Legs (3) into one of the Frames (5)
and line up the holes.
Use the supplied Allen Wrench to insert four M6x10
Machine Screws (10) through the holes on the Frame
(5) going into the Leg (3). Rotate each screw just a
few turns until all four are inserted, then tighten
them. Do the same for the other Leg and Frame.
HOW TO ORDER
1.800.676.6123
STEP 3
Slide the Side Brackets (4) into both Frames (5). Attach the
brackets using four M6x14 Machine Screws (9).
STEP 4
Slide the Center Rails (6) into the 120° Frames (7,8) and
attach them into position using sixteen of the M6x10
Machine Screws.
|
sales@progressiveautomations.com
|
www.progressiveautomations.com
Page 4 of 7
Advertisement
Table of Contents
