Related Manuals for progressive automations flt-02
Summary of Contents for progressive automations flt-02
-
Page 1: Table Of Contents
FLT-02 User Manual Contents Page 2 Caution/Liability Page 3 Technical Specifications Page 4 Parts Assembly Instructions Page 5-7 Operational/Reset Procedure, Page 8 Troubleshooting Page 9 Dimensions... -
Page 2: Caution/Liability
Caution Liability... -
Page 3: Technical Specifications
Technical Specifications Input Voltage 120 VAC, 60 Hz Output Voltage 24 VDC Stroke 25.5" Weight Capacity 270lbs (135 lbs Per Leg) Speed 1.30"/sec Height Range 23.5” - 49” (without table top) Duty Cycle 10% Max. 2 mins on, 18 mins off Material Steel Certification... -
Page 4: Parts
Parts Legs Center Rail x2 Foot Cable Frame End-CB Frame End Side Bracket A Side Bracket B Cable Clip x10 Control Box Power Cord Remote M6x10 Machine M6x14 Machine M6x35 Machine M5x20 Wood M5x16 Wood Screw Screw Screw Screw Screw Components Foot Frame End CB... -
Page 5: Assembly Instructions
Assembly Instructions STEP 1 Before you start make sure to lay out all the components and hardware to ensure you have all the necessary parts listed on the parts page. Separate the Frame Ends (3a,3b) and you will find the Center Rails (4) inside. STEP 2 Place one of the Legs (1) into the Frame End-CB (3a) STEP 4... - Page 6 Assembly Instructions STEP 6 STEP 8 Depending on your desktop, it may or may not be pre- Make sure that the wood screws are not too long for your drilled. Make sure to check both sides of the desktop desktop, otherwise they will puncture the surface once before placing the assembled unit on the underside of screwed all the way in.
- Page 7 Assembly Instructions STEP 9 IMPORTANT Connect the cable from the Leg (1) that is attached to the You must reset the desk prior to use: Frame End-CB (3a) directly into the Control Box (6). Then To reset you must press and hold the DOWN button on Slide the Control Box (6) into the Frame End-CB (3a).
-
Page 8: Operational/Reset Procedure
Operational Procedure Once your table lift is installed, operation is simple. Using the wired remote will allow full control over extending and retracting the lift columns. Use the up button to raise the table lift and the down button to lower the table lift. You can program up to 4 locations using the memory setup: Use the up/down buttons on the remote to find your desired height(s), then press “M”... -
Page 9: Dimensions
Dimensions 22.6" 49" 2" 27.5" 72.4" 43" 0.3" 17.7" 8.2" 10" 10"...