Changing Advanceddisk Disk Volume State; Deleting An Advanceddisk Disk Pool - Symantec NetBackup Manual

Changing AdvancedDisk disk volume state

Deleting an AdvancedDisk disk pool

To change AdvancedDisk disk pool state
1 In the NetBackup Administration Console, in the left pane, select Media
and Device Management > Device Monitor.
2 Select the Disk Pools tab.
3
Select the disk pool.
4 Select either Actions > Up or Actions > Down.
Use the NetBackup
nbdevconfig
is UP or DOWN.
To change the state to DOWN, the disk pool in which the volume resides must not
be busy. If backup jobs are assigned to the disk pool, the state change fails. Cancel
the backup jobs or wait until the jobs complete.
NetBackup jobs still read from and write to a disk pool that has a downed volume,
but the downed volume is unavailable.
To change the AdvancedDisk disk volume state
1 Determine the name of the disk volume. The following command lists all
volumes in the specified disk pool:
nbdevquery -listdv -stype AdvancedDisk -dp disk_pool_name
The
nbdevquery
UNIX: /usr/openv/netbackup/bin/admincmd
Windows: install_path\netbackup\bin\admincmd
To display the disk volumes in all disk pools, omit the
2
Change the disk volume state. The following is the command syntax:
nbdevconfig -changestate -stype AdvancedDisk -dp disk_pool_name
–dv vol_name -state state
The
nbdevconfig
UNIX: /usr/openv/netbackup/bin/admincmd
Windows: install_path\netbackup\bin\admincmd
The state is either UP or DOWN.
If you delete a disk pool, NetBackup removes it from your configuration.
command to change disk volume state. The state
command resides in the following directory:
command resides in the following directory:
Managing AdvancedDisk
Managing AdvancedDisk disk pools
option.
-dp
43