Symantec NetBackup Manual page 156

156 Configuring the Shared Storage Option
Verifying your Shared Storage Option configuration
2 Execute the command. The
scan
properties.
The following is example output:
*************************************************************
********************** SDT_TAPE
********************** SDT_CHANGER **************************
*************************************************************
Device Name : "/dev/sg/h3c0t0l0"
Passthru Name: "/dev/sg/h3c0t0l0"
Volume Header: ""
Port: -1; Bus: -1; Target: -1; LUN: -1
Inquiry : "ADIC Scalar 100 3.10"
Vendor ID : "ADIC "
Product ID : "Scalar 100 "
Product Rev: "3.10"
Serial Number: "ADIC009K0340314"
WWN : ""
WWN Id Type : 0
Device Identifier: ""
Device Type : SDT_CHANGER
NetBackup Robot Type: 6
Removable : Yes
Device Supports: SCSI-2
Number of Drives : 6
Number of Slots
Number of Media Access Ports: 10
Drive 1 Serial Number
Drive 2 Serial Number
Drive 3 Serial Number
Drive 4 Serial Number
Drive 5 Serial Number
Drive 6 Serial Number
Flags : 0x0
Reason: 0x0
------------------------------------------------------------
Device Name : "/dev/st/nh3c0t5l0"
Passthru Name: "/dev/sg/h3c0t5l0"
Volume Header: ""
Port: -1; Bus: -1; Target: -1; LUN: -1
Inquiry : "QUANTUM DLT7000
Vendor ID : "QUANTUM "
Product ID : "DLT7000
output shows the robot and the drive
scan
**************************
: 50
: "PXB03S0979"
: "PXB03S0913"
: "CXA04S2051"
: "PXA31S1787"
: "PXA37S3261"
: "PXA50S2276"
"
2561"