Changing Openstorage Storage Server Properties; Deleting An Openstorage Storage Server; Determining Openstorage Storage Server State - Symantec NetBackup Manual

106 Managing OpenStorage
Managing OpenStorage storage servers

Changing OpenStorage storage server properties

Deleting an OpenStorage storage server

Determining OpenStorage storage server state

You can change the OpenStorage storage server properties. The storage vendor
exposes the properties that you can change.
See About OpenStorage storage servers"
To change deduplication storage server properties
1 In the NetBackup Administration Console, expand Media and Device
Management > Credentials > Storage Server
2 Select the storage server.
3 On the Edit menu, select Change.
4 In the Change Storage Server dialog box, select the Properties tab.
5 To change a value, select it in the Value column and then change the value.
6 When finished changing values, click OK.
7 Click OK.
If you delete a storage server, NetBackup removes it from your configuration.
If a disk pool is configured from the disk volumes that the storage server manages,
you cannot delete the storage server.
Warning: Do not delete a storage server if its storage contains unexpired NetBackup
images; if you do, data loss may occur.
To delete an OpenStorage storage server
1
In the NetBackup Administration Console, in the left pane, expand Media
and Device Management > Credentials > Storage
2
On the Edit menu, select Delete.
3 Click Yes in the confirmation dialog box.
Use the NetBackup
nbdevquery
storage server.
To determine OpenStorage storage server status
Run the following command:
on page 61.
command to determine the state of an OpenStorage