Table of Contents
Advertisement
CVS-872D
1.2.2
Flush-mount installation
(1) Make a square hole at the location to be installed (See Fig. 1.5)
(2) Remove four plastic corner caps of the Display unit (These can be easily pulled out
upwards).
(3) Confirm that the unit matches the square holes. If not matched, correct the square hole.
(4) Connect the connectors for power and transducer to the unit respectively.
(5) Install the Display unit in the installing location (square hole) and fix it with four tapping
screws (4mm) (M4 or pan-head). (Prepare 4 mm screws suitable for thickness of
installing location.)
(6) Install the corner caps removed in step (2).
Screw covers (4 pcs)
M4 screw (4 pcs)
Display unit
Fig. 1.5 Hole for flush-mount installation of Display unit
0092607062-01
Fig. 1.4 Flush-mount installation
308
(12 1/8)
4 holes for 4 mm screw
Threading hole
274
16
(10 25/32)
(5/8)
306
(12 3/64)
Chapter 1 Installation
16
(5/8)
Unit: mm (inch)
1-5
Advertisement
Table of Contents
