Rigging Procedures; Wall- Or Ceiling-Mounting X4I With A Bracket - L-Acoustics X4i Owner's Manual

Rigging procedures

Rigging procedures

Wall- or ceiling-mounting X4i with a bracket

type of deployment
rigging accessories
additional material
tools
Secondary safety for own enclosures
Use one insert at the back of the enclosure to implement a secondary safety.
Fasteners for wall-mounting or ceiling-mounting
Secure the bracket with two M6 screws.
Select screw length and anchors applicable to the wall or ceiling properties.
The procedure is shown with X-U4i.
The same procedure applies for X-B4i.
Assembly
Procedure
1. Secure X-U4i or X-B4i to the wall or to the ceiling using two M6 screws.
70 mm / 2.8 in
2 x Ø 6.6 mm /
0.26 in
X-U4i
2. On both sides of the enclosure, remove the screws.
32
wall-mounting
ceiling-mounting
X-U4i or X-B4i
2 x ∅ 6 mm / M6 screws and anchors (depending on the support material)
blue threadlocker
torque screwdriver
T25 Torx bit
70 mm / 2.8 in
2 x Ø 6.6 mm /
0.26 in
X-B4i
T25
X4i owner's manual (EN) version 4.0