Siemens SIMOTION Equipment Manual page 51

Interface assignment X21
Table 4-8 PROFIBUS DP/MPI interface (X21)
Representation
1
9
The 1P5 voltage is provided exclusively for the bus terminal.
No OLPs are permitted.
Signal type: VO = Voltage output (power supply); O = Output; B = Bidirectional
X24 interface assignment
Table 4-9 PROFIBUS DP interface X24 (SIMOTION D410‑2 DP only)
Representation
1
9
The 1P5 voltage is provided exclusively for the bus terminal.
No OLPs are permitted.
Signal type: VO = Voltage output (power supply); O = Output; B = Bidirectional
Connectable devices
The following devices can be connected to the PROFIBUS DP interfaces:
• PG/PC
• SIMATIC HMI devices
SIMOTION D410-2
Equipment Manual, 07/2021, A5E33446720B
Pin Signal name
1 -
2 M
3 1RS_DP
4 1RTS_DP
5 1M
6 1P5
7 P24_SERV
8 1XRS_DP
9 -
Pin Signal name
1 --
2 M
3 2RS_DP
4 2RTS_DP
5 1M
6 1P5
7 P24_SERV
8 2XRS_DP
9 --
Signal Meaning
type
- Reserved, do not use
VO Ground to P24_SERV
B RS-485 differential signal
O Request to send
VO Ground to 1P5
VO 5 V power supply for bus terminal, external, short-circuit proof
VO 24 V for teleservice, short-circuit proof, 150 mA maximum
B RS-485 differential signal
- Reserved, do not use
Signal Meaning
type
-- Reserved, do not use
VO Ground to P24_SERV
B RS-485 differential signal
O Request to send
VO Ground to 1P5
VO 5 V power supply for bus terminal, external, short-circuit proof
VO 24 V for teleservice, short-circuit proof, 150 mA maximum
B RS-485 differential signal
-- Reserved, do not use
Interfaces
4.3 PROFIBUS DP interfaces
51