Document Feeder Tray - Sharp AR-M160 Operation Manual

Copying from the SPF/RSPF
1
Make sure that an original has not
been left on the document glass.
Close the SPF/RSPF.
2
Adjust the original guides to the size
of the original(s).
3
Set the original(s) face up in the

document feeder tray.

G Insert the original into the document feeder tray as
far as it will go. When the original is set, the
SPF/RSPF indicator will light up.
G The ORIGINAL SIZE indicator corresponding to the
size of the original lights up.
G Make sure that the ORIGINAL TO COPY indicators
are not lit. (When automatic two-sided copying is
supported.)
G Make sure that the PAPER SIZE indicator is lit.
G If the indicator is not lit, no tray has the same size of
paper as the original. Load paper of the required
size in a tray, or select the bypass tray with the
[TRAY SELECT] key (
bypass tray.
G The bypass tray must be manually selected.
G To copy on paper of a different size than the
original, select the paper with the [TRAY SELECT]
key ( ).
Do not place originals of different sizes
Note
together in the document feeder tray. This
may cause misfeeds.
4
Set the number of copies.
) and copy from the
5
Press the [START] key (
copying.
START
• The paper output tray can hold up to 250
Note
sheets of paper.
• About one minute after copying ends, "Auto
clear timer" activates and restores the copy
settings to the initial settings. (p.12) The
setting for "Auto clear time" can be changed
in the user programs. (p.44)
• Press the [CLEAR] key (
copying in the middle of a run.
• If you find it difficult to remove the original
from the document feeder tray, open the
feeding roller cover first and then remove
the original. If you remove the original
without opening the feeding roller cover, the
original may become dirty.
COPY FUNCTIONS
) to begin
The copy is delivered to
the paper output tray.
) to stop
19
2