Replacing The Toner Cartridge - Sharp AR-M160 Operation Manual

REPLACING THE TONER CARTRIDGE

When the toner cartridge replacement required indicator (
soon. Obtain a new cartridge. When the toner cartridge replacement required indicator (
cartridge must be replaced before copying can be resumed.
Replace the toner cartridge by following the procedure below.
Note
When the toner cartridge replacement indicator (
1
Push on both ends of the front cover
and open it.
2
Pull the toner cartridge out while
pressing the lock release lever.
Toner cartridge
lock release lever
After removing the toner cartridge, do not
shake it or tap on it. Doing so may cause
Caution
toner to leak from the cartridge. Put the old
cartridge immediately in the bag contained in
the box of the new cartridge. Dispose of the
old toner cartridge in accordance with local
regulations.
3
Remove the new toner cartridge from
the bag. Grasp the cartridge on both
sides and shake it horizontally four or
five times. After shaking the cartridge,
remove the tape.
4 or 5 times
Shutter
tape
• Grasp the grip when holding the cartridge.
Do not hold the cartridge by the shutter.
Caution
• Be sure to shake the cartridge only before
the tape is removed.
70
) lights up, the toner cartridge will need replacement
) blinks, little toner remains and thus copies may be faint.
4
Insert the toner cartridge along the
guides until it locks in place while
pushing the lock release lever.
5
Remove the tape from the shutter. Pull
the shutter out of the toner cartridge.
6
Close the front cover.
• Even after a new toner cartridge is installed,
Note
the toner cartridge replacement required
indicator (
that copying cannot be resumed (toner is
not fed sufficiently). In this case, open and
close the front cover. The machine will feed
toner again for about two minutes and then
copying can be resumed.
• Before closing the front cover, make sure
that the toner cartridge is correctly installed.
• When closing the front cover, press on both
ends.
) blinks, the toner
If there is any dirt or dust
on the toner cartridge,
remove it before
installing the cartridge.
Discard the shutter.
The toner cartridge
replacement required
indicator ( ) will go
out.
) may still light up, indicating