Setting The Layout Pattern - Sharp AR-M160 Operation Manual

Using the SPF/RSPF
1
Place the originals. (p.19)
2
Press the [2 IN 1 / 4 IN 1] key to select
the mode.
2 IN 1 2 IN 1
4 IN 1 4 IN 1
3
Set the number of copies and other
settings, and press the [START] key (
The copy is delivered to the paper output tray.

Setting the layout pattern

You can select the layout pattern for copying 2 original pages or 4 original pages onto one sheet of paper. The
available layout patterns are shown on the first page of this section.
Note
The layout pattern can also be selected in the user programs. (p.44)
1
Use the [2 IN 1 / 4 IN 1] key to access
the setting.
Selecting the layout for 2 IN 1 copy
With the 2 IN 1 / 4 IN 1 indicators off, hold down the [2
IN 1 / 4 IN 1] key until the 2 IN 1 indicator blinks.
2 IN 1
4 IN 1
Selecting the layout for 4 IN 1 copy
With the 2 IN 1 indicator lit, hold down the [2 IN 1 / 4 IN
1] key until the 4 IN 1 indicator blinks.
2 IN 1
4 IN 1
The mode is selected in
the order "2 IN 1", "4 IN
1", "Off".
).
The setting code of the
currently selected pattern
will blink in the first digit
of the display.
The setting code of the
currently selected pattern
will blink in the first digit
of the display.
CONVENIENT COPY FUNCTIONS
• To cancel 2 IN 1 / 4 IN 1 copying, press the
Note
[CLEAR] key
• To cancel 2 IN 1 / 4 IN 1 copy mode, press
the [2 IN 1 / 4 IN 1] key repeatedly until the
2 IN 1 / 4 IN 1 indicators are both off.
If the memory becomes full
• If the memory becomes full while scanning the
originals, the ORIGINAL DATA indicator will
blink, "FUL" will appear in the display, and the
machine will stop copying. In this state, the
paper tray cannot be changed.
• To copy the originals that have been scanned up
to that point, press the [START] key (
• To clear the data that has been scanned into
memory, press the [CLEAR ALL] key (
[CLEAR] key ( ).
2
Select the setting code by pressing a
numeric key.
READ END
Function
* 1 (Pattern 1)
2 IN 1 layout
2 (Pattern 2)
* 1 (Pattern 1)
2 (Pattern 2)
4 IN 1 layout
3 (Pattern 3)
4 (Pattern 4)
The factory default settings are indicated by " * ".
The entered number blinks in the first digit of the display.
3
Press the [START] key (
The selected setting code stops blinking and
lights steadily. This completes the setting.
4
Press the [2 IN 1 / 4 IN 1] key to exit
the setting.
The display returns to the number of copies display.
( )
.
).
) or the
To select "Pattern 2",
press the [2] key.
Setting code (p.45)
).
35
3