Erasing Shadows Around The Edges Of A Copy; Erase Copy - Sharp AR-M160 Operation Manual

ERASING SHADOWS AROUND THE
EDGES OF A COPY
● This feature is used to erase shadows that appear around the edges of copies of books and other thick originals.
(EDGE ERASE)
● The feature can also erase the shadow that appears down the center of books and other originals that open up.
(CENTER ERASE)
● The factory default setting for the width of the erasure is approximately 1/2". The width can be changed in the
user programs. (p.45)
EDGE ERASE
CENTER ERASE
A B A B
Original
• Center erase cannot be used in combination with dual page copy.
Note
• Erase copy cannot be used in combination with 2 IN 1 / 4 IN 1 copy. (p.34)
• Erase copy cannot be used when the paper is a special size or copying from the bypass tray.
• Note that if the width of the erasure is too large, the edge of the image may be partially erased.
1
Place the original(s). (p.18)
2
If the original is placed on the
document glass, select the original
size. (p.18)
When using the SPF/RSPF, make sure that the
same ORIGINAL SIZE indicator as your original
size lights up.
3
Press the [ERASE] key to select the
desired erase mode.
EDGE
ERASE
CENTER
A A
Original Copy
Copy
To select the "EDGE +
CENTER ERASE" mode,
press the [ERASE] key
until both the EDGE and
CENTER indicators light
up.
EDGE + CENTER ERASE
A B A B
Original
4
Set the number of copies and other
settings, and then press the [START]
key ( ).
The copy is delivered to the paper output tray.
• To cancel erase copy, press the [ERASE]
Note
key repeatedly until the ERASE indicators
are both off.
• If the original size was not selected in step
2, erase copy cannot be used.

(Erase copy)

Copy
37
3