Table of Contents
Advertisement
Protouch2 GUI User Manual
9.4.5.2 Mass Program
Multiple devices can be programmed one after the other by using the Mass Program
option. Select the hub of interest. Configuration file and/or Firmware File should be
selected one time before programming.
9.4.6 Programming time
It takes about 3 to 5 seconds for programming if the internal HCE (Hub Controller
Enumeration) device is enabled.
Otherwise it takes about 14 to 20 seconds depending on the OS (Win 7 or 8.1) and
architecture (32 or 64 bit)
MICROCHIP CONFIDENTIAL
Page 30
Advertisement
Table of Contents
Need help?
Do you have a question about the Protouch2 and is the answer not in the manual?
Questions and answers