Basic Workflow (Scanning Images) - AGFA DX-G User Manual

60 | DX-G, DX-M | Getting started

Basic Workflow (Scanning Images)

Workflow:
1. Identify the cassette with the ID Tablet and on a workstation.
2. Check that the digitizer is ready for operation.
The status indicator must be continuously lighting up green or green
flashing.
3. Put the cassettes with the exposed and identified image plates in the input
buffer on the left side of the digitizer.
There can be up to five cassettes in the input buffer.
4. Be aware of the orientation of the cassettes:
1.
2.
Figure 5: Cassette orientation
2321G EN 20181126 1428
Note: The basic workflow is described in the DX-G/DX-M Workflow
Sheets.
WARNING:
Do not apply excessive shock or vibration to the digitizer, for
example dropping of cassettes into the buffer during
operation. This may decrease the image quality. Lower
cassettes gently into the buffer.
2
Tube side must be faced to the operator.
The shutter opening mechanism and locking mechanism must be
pointed down, to the slot of the digitizer.
1