The User Interface; Status Indicator - AGFA DX-G User Manual

56 | DX-G, DX-M | Getting started

The User Interface

The digitizer has two operation modes:
• the operator mode for basic operation,
• the service mode reserved for trained service personnel.
The functions of the operator mode are described in this manual.
The digitizer interfaces with the user via:
• a touch panel which enables access to all functions,
• a status indicator.

Status indicator.

1.
Touch panel.
2.
On/Off switch (main switch).
3.
Ethernet connection (located at the rear side).
4.
Figure 4: User interface
Status Indicator
The indicator informs the user by light signals about the status of the digitizer
(e.g. image plate erasing cycle progress, operational indications such as warm
up,...). It is positioned at the front of the digitizer, so that it is visible from a
distance.
2321G EN 20181126 1428
1
2
4
3