AGFA DX-G User Manual page 22

22 | DX-G, DX-M | Introduction
8. Insert the tool in the opening and turn the screw counterclockwise, until
the digitizer is lifted up approximately 1,5-2 cm, until you encounter
resistance.
The digitizer is ready to be moved to another location.
9. Move the digitizer to the desired location.
10. Once on the desired site, turn the screw clockwise until the digitizer is
fixed on the ground and you encounter resistance.
Now the digitizer is ready for operation.
2321G EN 20181126 1428
1,5 - 2 cm
0.59 - 0.78 inch
WARNING:
Observe great care when moving the digitizer to the desired
location. So please select a path free from inclinations and
thresholds to prevent the digitizer from shocks during
movement.
WARNING:
Operating the digitizer in a not-fixed condition may result in
image artefacts.