Advertisement
Step 6: Hang the assembly onto the Wall Plate
CAUTION: This step may require two people to lift the assembly onto the Wall Plate. Sanus is not responsible for injury or
damage.
Orient the Arm Assembly (B) so that the arm extends directly away from the television and the Transfer Plate is parallel with the television.
Lift the assembly, and hook the Transfer Plate onto the Tab on the top of the Wall Plate (A) as shown in Diagram 6A. Adjust the Transfer
Plate side to side on the Wall Plate until it is in the desired location.
CAUTION: make sure the Saftey Bolt (M) is tight. A loose Safety Bolt will result in an unstable installation which may result in
property damage and/or personal injury.
Thread each Safety Bolt (M) into one of the two holes in the bottom of the Transfer Plate and tighten them with the Allen Key (J) so that
they are behind the tab on the bottom of the Wall plate as shown in Diagram 6B.
Diagram 6A
Transfer
Plate
Step 7: Leveling the Monitor and Adjusting the Tension
CAUTION: Do not remove the Tension Nuts labeled in Diagram 7A. Removing the Tension Nuts may cause the television to
fall, resulting in property damage and possible personal injury.
Once the television is mounted onto the Wall Plate (A), and the Safety Bolts (M) are tight, it can be adjusted to level. Slightly loosen the
two Allen Bolts on the back of the Arm Assembly (B). Once those two Allen Bolts are loosened, the television can be adjusted ±6º until
level. When the television is level retighten the two Allen Bolts. The tilt can be adjusted by simply tilting the TV. To adjust the tension of tilt,
use the Tension Knobs. The Tension Nuts labeled in Diagram 7A can be slightly loosened or tightened by using the 7/32 Allen Key (J) and
a wrench to adjust the tension of the Arm Assembly. If you need to adjust the Tension Nut closest to the TV, you must remove the Safety
Bracket as shown in Diagram 7B, using the 7/32 Allen Key and the Safety Bracket as a wrench (See Diagram 7C) adjust the tension and
re-install the Safety Bracket as shown in the Safety Bracket installation view of Diagram 7B.
Diagram 7A
Tension
Knobs
Wall
B
Tab
A
Tension
Tension
Diagram 7B
Nut
Nut
Allen
Bolts
Diagram 6B
M
Safety
Bracket
A
Tab
Diagram 7C
Safety
Bracket
Advertisement
