Advertisement
Step 3: Add the Vise Assemblies to the Monitor Brackets:
NOTE: Do not overtighten the 1/4-20 Nut (L). The Vise Assembly (E) should be able to rotate freely around the Carriage Bolt (K).
Place the Vise Assembly (E) between the two sides of the Monitor Bracket (D) so that the two jaws point toward the set of 1" diameter
holes and the Allen Bolt is facing away from the television. Place a 2" Carriage Bolt (K) through the square hole in the side of the Monitor
Bracket, through the hole in the Vise Assembly, and through the square hole in the other side of the Monitor Bracket. Tighten a 1/4-20 Nut
(L) onto the end of the 2" Carriage Bolt. Repeat this step for the bottom of the Monitor Bracket. Repeat these two steps for the second
Monitor Bracket. See Diagram 3 for assistance.
Diagram 3
Detail View
Jaws
Allen
I" Diameter
Bolt
Hole
E
K
L
Step 4: Attach the Arm Assembly to the Television
Orient each Vise Assembly (E) so that a 1" Diameter Tube (C) will pass through the 1" round hole in the Monitor Bracket (D), and between
the jaws of the Vise Assembly. Insert a 1" Diameter Tube through the top hole in the first Monitor Bracket. Repeat this step for the Bottom
hole in the same Monitor Bracket. See Diagram 4A for assistance.
Diagram 4A
C
E
D
E
C
Step 4: Attach the Arm Assembly to the Television (Continued on next page.)
Advertisement
