Before Installation; Important Safety Instructions - Circutor URBAN WB DC Series Installation Manual

2
A
I m p o r t a n t S a f e t y I n s t r u c t i o n s
The Charge Point is designed for installation in indoor and outdoor areas. For
each of the different conditions of installation, the device must be installed safely
and ensure adequate protection.
• Charge Point must not be installed in
areas where there is potential risk of
explosions or any salinity level.
• Charge point must not be installed in
industrial areas with high level of humidity
or pollutants.
• Do not install the Charge Point where
falling objects may damage the
equipment.
• The surface where the Charge
Point is placed must withstand the
mechanical forces.
• Do not use this device for anything
other than electric vehicle charging
modes are expected in IEC 61851.
• Do not modify this device. If modified,
CIRCUTOR will reject all responsibility
and the warranty will be void.
• Comply strictly with electrical safety
Refer to TECHNICAL DATA section for more information about environmental
installation conditions.
8
Read carefully all the instructions before starting in or-
der to ensure properly installation of the Charge Point.
regulations according to your country.
• Do not make repairs or manipulations
with the device energised.
• Only trained and qualified personnel
should have access to electrical parts
inside the Charge Point.
• Check the installation annually by
qualified technician.
• Remove from service any item that
has a fault that could be dangerous
for users (broken plugs, caps that
don't close...).
• Use only CIRCUTOR supplied spare
parts.
• Do not use this product if the
enclosure or the EV connector is
broken, cracked, open, or shows any
other indication of damage.
URBAN WB DC
Installation Guide