Regulating The Suction Power; Cleaning The Hepa Filter; Cleaning The Exhaust Air Filter - Tesla BG200R User Manual

Regulating the suction power

You can set the suction power on the device individually as you
require it using the suction regulator. We recommend using minimum
suction power for delicate materials.
Select medium suction power for mattresses, upholstered furniture
and carpets. Select maximum suction power for tiled, wood and other
robust floors.

Cleaning the HEPA filter

The HEPA filter and the HEPA cover should be cleaned regularly. Cleaning is best done when emptying the dust container.
To do this follow the instructions in the Emptying dust container section.
1. Switch off the vacuum cleaner and disconnect the plug from the mains. To do this always pull on the plug and not on
the cable.
2. You can pull the dust container together with the cleaning system out of their anchoring with the aid of the carrier
handle on the dust container. Take hold of the carrier handle on the dust container and pull it upwards. Now pull
the dust container out and loosen the HEPA cover and HEPA filter out of the dust container with the aid of the lateral
unlocking button.
3. Turn the dust container cover carefully until it is released and the HEPA filter will come away easily
4. Now rinse the HEPA filter under running water and allow it to dry.
5. Place the HEPA filter back in the HEPA cover (or replace with a new one) and fit it into the dust container. Then fit the
dust container back into position in the cyclone dust container until it snaps into place. Your cyclone vacuum cleaner is
now ready for use again.

Cleaning the exhaust air filter

The exhaust air filter cleans the air a final time before it leaves the vacuum cleaner. You can clean the exhaust air filter as
follows:
1. Switch off the vacuum cleaner and disconnect the plug from the mains. To do this always pull on the plug and not on
the cable.
2. Open the exhaust air grill (this is at the rear of the cyclone vacuum cleaner.)
3. The exhaust air filter is visible when the grill has been opened.
4. Rinse the filter under cold running water and allow dry.
5. Put the exhaust air filter back into place (or replace with a new one) and place in the grill.
6. Close the exhaust air filter grill.
7