Maserati Grecale 2022 Owner's Manual page 76

Before Starting
(Continued)
• Pinch protection is disabled while
pressing the switch/es.
Initialisation Procedure
Automatic operation of the sunroof must
be initialised again in case of faulty
sunroof operation.
NOTE:
3
The pinch protection function is
deactivated during the initialisation
procedure.
Proceed as follows:
• set the ignition device to ON position
starting the engine;
• press the (1) button to bring the sunroof
into completely closed position;
• open the driver side door;
• bring the ignition device into STOP
position;
• within 5 seconds, set the ignition
device to ON position starting the
engine;
• within 10 seconds hold the (1) button
pressed; after 10 seconds you will hear
the electric motors of the sunroof and
sunshade stop in sequence;
• release the button and within 5
seconds, press the (1) button and
hold it down (until the cycle end): the
sunroof will automatically perform
a complete open and close cycle
including both the sunroof and
the sunshade (to indicate that the
74
initialisation has been successful). If
this does not occur, the procedure must
be restarted from the beginning;
• check that the re-initialisation operation
was successful by checking the "one
touch" function of the sunroof and of
the sunshade.
Wind Buffeting
Wind buffeting can be described
as the perception of pressure or a
helicopter-type sound. Your vehicle may
exhibit wind buffeting with the windows
down, or the sunroof in certain open or
partially open positions. This is a normal
occurrence and can be minimised.
If the buffeting occurs with the rear
windows open, then open the front and
rear windows together to minimise the
buffeting. If the buffeting occurs with the
sunroof open, then adjust the sunroof
opening to minimise the buffeting.
Ignition STOP Operation
The power sunroof controls will remain
active for up to approximately ten
minutes after the ignition device is in
STOP position. Opening either front door
will cancel this function. The ignition
system timing can be set using the MIA
system (see "Functions of Settings
Menu on MIA" in section "Dashboard
Instruments and Controls").
Sunroof Maintenance
Use only a nonabrasive cleaner and a
soft cloth to clean the glass panel.