Maserati Grecale 2022 Owner's Manual page 144

Dashboard Instruments and Controls
If the windshield washer is used with
the rain sensor activated, the normal
washing cycle is performed, after which
the rain sensor resumes its normal
automatic operation.
CAUTION!
• Keep the glass in the sensor area clean.
•
With the windshield wiper ring turned
to the or position, wiping
operates automatically and is disabled
when the outside temperature is below
4
0 °C (32 °F).
• Use on the windshield of RainX
products containing wax or silicone
may reduce rain sensor performance.
Deactivation
Use ring of the right multifunction lever
or place the ignition device in STOP
position.
In the event of malfunction of the rain
sensor whilst it is active, the windshield
wiper operates intermittently at a speed
consistent with the sensitivity setting of
the rain sensor, regardless of whether
there is rain on the glass, while sensor
failure is indicated on the display (see
"Warning and Indicator Lights" in this
section).
The sensor continues to operate and it is
possible to set the windshield wiper to
continuous mode
142
indication remains for as long as the rain
sensor is active.
The rain sensor is able to recognize,
and automatically adjust itself in the
presence of the following conditions:
• presence of dirt on the controlled
surface (e.g. salt, dirt, etc.);
• presence of streaks of water caused by
the worn window wiper blade;
• difference between day and night.
Do not activate the rain sensor when
washing the car in an automatic car
®
or
wash.
Rear Window Wiper/Washer
Engaging reverse gear with the
windscreen wiper operating activates a
single cycle of the rear window wiper.
Moving the multifunction lever towards
the dashboard activates the rear window
washer (a brief push activates one
washing cycle, keeping the multifunction
lever pushed washes continuously until
the lever is released).
Moving the multifunction lever
downwards (with reverse gear engaged)
activates/deactivates the continuous
operation of the rear window wiper,
regardless of the movement of the
windscreen wiper.
or . The failure
CAUTION!
Moving the multifunction lever
downwards (with reverse gear not
engaged) activates/deactivates the
intermittent operation (with actuating
frequency of about 3 seconds) of the
rear window wiper, regardless of the
movement of the windscreen wiper.
Pushing the button on the right
multifunction lever, the rear wiper will
start cleaning the rear window without
activating the washer jet until the button
is pressed again.
WARNING!
Make sure the device is turned off
whenever the windscreen glass must be
cleaned.