Synchronising the Rolling Codes
At the end of the previously-described
programming, if the HomeLink
programmed for a rolling code system,
it will be necessary to synchronise it to
ensure its correct operation.
•
Locate the "LEARN" or "TRAINING"
setting button of the opening motor.
Firmly press it and then release it. On
some garage door openers/devices
there may be a light that blinks when
the garage door opener/device is in the
LEARN/TRAIN mode.
NOTE:
You have 30 seconds to initiate the next
step after the setting button has been
pressed.
•
Return to the vehicle and press the
®
programmed HomeLink
button for two
seconds and then release it.
•
Repeat this operation a second time.
If the garage door opening device
activates, the programming/
synchronization phase is complete.
NOTE:
If the garage door opening device
does not activate, press the button
a third time for two seconds and
then release it to complete the
programming/synchronization phase.
•
To program the remaining two
®
HomeLink
buttons, repeat the same
step for the same remaining button. DO
NOT erase the channels.
®
has been
Reprogramming a Single HomeLink
Button
To reprogramme a channel that has been
previously trained, follow these steps:
•
Place the ignition device to ON position
without starting the engine.
•
Press and hold the desired HomeLink
button.
•
Without releasing the button proceed
with "Programming the hand-held
transmitters" from second step and
follow all remaining steps.
System with Devices Without
Rolling Code
Programming the Hand-held
Transmitters Manufactured before 1995
•
Turn the ignition device to ON position
without starting the engine.
•
Place the hand-held transmitter 5 to
30 cm (1 to 3 inches) away from the
®
HomeLink
button you wish to program.
•
Simultaneously press and hold both
buttons until the warning light starts
flashing quickly; then release both
buttons.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
Understanding the Vehicle
NOTE:
The distance necessary between the
portable hand-held transmitter and the
®
®
HomeLink
system you wish to program. Probably
it will be necessary to try several times.
Upon every attempt, keep the setting
position for at least 15 seconds before
trying again.
®
•
Press and hold the programmed
HomeLink
If the garage door opener/device
activates, programming is complete. To
program the remaining two HomeLink
buttons, repeat each step for each
remaining button. Do not erase the
channels.
Reprogramming a Single HomeLink
Button
To reprogram a channel that has been
previously trained, follow these steps:
•
Place the ignition device to ON position
without starting the engine.
•
Press and hold the desired HomeLink
button.
•
Without releasing the button proceed
with "Programming the hand-held
transmitters" from second step and
follow all remaining steps.
Using HomeLink
®
system.
To operate, press and release the
programmed HomeLink
in the vehicle depends on the
®
button.
®
®
®
®
®
button.
2
53