Maserati Grecale 2022 Owner's Manual page 225

Push the ON/OFF button a second time
and release to turn the system off. A pop
up message is displayed for 2 seconds
to indicate that ACC was disabled.
WARNING!
Leaving the Adaptive Cruise Control
(ACC) system on when not in use is
dangerous. You could accidentally
activate the system or cause it to go
faster than you want. Always leave the
system off when you are not using it.
Setting the Speed
When vehicle reaches required speed,
press an release the button (SET -).
The display will show set speed
corresponding to vehicle current one.
Speed value will be indicated beside the
green symbol and above the distance
bars, in the centre of the display.
Remove foot from accelerator pedal and
vehicle will continue at set speed.
Driver Assistance Systems
Driver Override
If driver accelerates beyond the set
speed or faster than the car would do
autonomously, the time gap bars will
become grey to remember that in this
condition the system cannot control the
distance between vehicle and sensed
vehicle ahead. Vehicle speed will be
determined only by the accelerator pedal
position.
Changing Speed Setting
Once speed is set, driver can increase or
decrease it by respectively pressing the
button (SET +) or down (SET -). Speed
can be increased or decreased in two
ways:
• Pressing control once, set speed will
increase or decrease by one unit
corresponding to 1 km/h (1 mph).
• Hold the control to increase or
decrease set speed by 10 km/h (5 mph)
at a time.
NOTE:
• When pressing the button (SET +) or
(SET -), the new set speed will be the
current speed of the vehicle.
• When using (SET -) control to
decelerate, if the engine braking power
does not slow down the vehicle
sufficiently to reach the set speed, the
6
(Continued)
223