Table of Contents
Advertisement
activated. See "Automatic Temperature
Control (ATC)" in this chapter for more
information.
9. MAX defrosting/demisting
Press the soft-key to switch the airflow
setting to the windshield and the front
side windows to get quick defrosting/
defogging. The soft-key illuminates in
amber when this function is activated.
Operating this function will cause the
ATC to switch into manual mode:
the "AUTO" soft-key will turn off.
With engine off, the blower will run at
minimum speed (level 1) and can be
increased manually: with engine on, the
blower speed will gradually increase
to the higher speed (level 8). MAX
defrosting/demisting shall also involve
REAR defrosting/demisting function. If
this function is turned off the climate
system will return to the previous
setting.
10. REAR defrosting/demisting
Press the soft-key to turn on the rear
window defroster and the heated
outside mirrors. The soft-key will
illuminate in amber when the rear
window defroster and the heated
external mirrors are on. The rear window
defroster and the heated external mirrors
automatically turn off after 10 minutes.
For any subsequent request after the
first one (in the current ignition cycle),
the system activates the function
for 5 minutes. The timing described
above is automatically reset and
the defrost/demisting function is
deactivated at each key-off.
CAUTION!
Failure to observe the following cautions
may cause damage to the rear windows
defroster:
•
Use care when washing the inside of
the rear window. Do not use abrasive
window cleaners on the interior surface
of the window. Use a soft cloth and a
mild washing solution, wiping parallel
to the heating elements. Labels can
be peeled off after soaking with warm
water.
•
Do not use scrapers, sharp instruments,
or abrasive window cleaners on the
interior surface of the window.
•
Keep all objects inside the vehicle at a
safe distance from the window.
11. MAX A/C
By pressing the "MAX A/C" soft-key, the
system automatically switches to get
the maximum cold air flow in both zones.
12-13 Air flow distribution modes
The airflow distribution mode,
respectively on the driver and on the
passenger zone, can be adjusted so air
comes from the dashboard vents, vents
Dashboard Instruments and Controls
under the dashboard in direction of the
floor, demist/defrost vents and vents
under the front seats and adjustable
vents at the rear end of the central tunnel
for the rear passengers only.
The Comfort Display shows the relevant
soft-keys to set these modes individually
for each zone.
Available settings are as follows:
•
"Dashboard" mode
Air for each zone flows from four
adjustable vents of the dashboard and
two positioned at the rear end of the
central tunnel. Each of these vents
can be singly adjusted. The air grids
or vanes of the vents can be moved
to adjust air flow direction. A setting
wheel, placed near each vent, allows to
regulate or close the airflow.
•
"Bi-Level" mode
Air for each zone flows from the
dashboard and central tunnel
adjustable vents and from the fixed
floor vents described in "Floor" mode.
NOTE:
Bi-Level mode is designed to let cooler
air come in the dashboard and rear part
of the central console vents and warmer
air from the floor vents.
•
"Floor" mode
Air for each zone flows from the
fixed front vents, located under the
4
145
Advertisement
Chapters
Table of Contents
