Use Of The Engine - Maserati Grecale 2022 Owner's Manual

Starting and Driving
of the power actuator might not be
sufficient to ensure vehicle braking,
especially on a slope.
Drive normally without braking to
allow the brakes to cool down a few
minutes before stopping. In this way,
the automatic or manual activation of
the parking brake will ensure vehicle
braking.
Brake overheating could also cause
"squeals" and "vibrations".
5
182

Use of the Engine

Breaking-In
Today's most modern production
methods are designed to provide
extremely precise construction and
assembly of components. However,
moving parts do undergo a settling
process, basically in the first hours of
vehicle operation.
Do not drive keeping at a constant high
speed rate for a prolonged time.
While cruising, brief full-throttle
acceleration within the limits of local
traffic laws contributes to a good break-
in. Wide-open throttle acceleration in
low gear can be detrimental and should
be avoided.
The engine oil installed in the engine
at the factory is a high-quality energy
conserving type lubricant. Oil changes
should be consistent with anticipated
climate conditions under which
vehicle operations will occur. For the
recommended viscosity and quality
grades, see "Refilling Table" in
section "Technical Specifications".
A new engine may consume some
oil during its first few thousand
kilometres/miles of operation. This
should be considered as a normal part of
the break-in and not interpreted as an
indication of malfunction.
Specific Requirements (2.0 L4 MHEV
Engines)
Avoid exceeding 5000 rpm for the first
1000 trip km (620 mi).
After starting the vehicle, do not exceed
4000 rpm until the engine has warmed
up sufficiently (coolant temperature: 65-
70°C / 149-158°F).
Specific Requirements (V6 Engine)
Follow these recommended guidelines
during the first 2414 km (1500 mi) of
driving this vehicle. Parts have a break-in
period and performance will be better in
the long run.
For the first 322 km (200 mi):
• To break in tires, drive at moderate
speeds and avoid hard cornering.
• New brake linings also need a break-in
period. Avoid making hard stops. This is
recommended every time brake linings
are replaced.
For the first 800 km (500 mi):
• Avoid full throttle starts and abrupt
stops.
• Do not exceed 4000 rpm.
• Avoid driving at any one constant
speed, fast or low, including the use of
cruise control.
• Avoid downshifting to break or slow
the vehicle when the engine speed will
exceed 4000 rpm.