Boiler & Pump Enable/Disable - Watts AERCO EXT Installation, Operation & Maintenance Manual

Ufly Controller and BCM for Modulex EXT
CHAPTER 4: UFLY SETUP AND PROGRAMMING
Viewing the DHW Setpoint:
The setpoint temperature setting is viewed in the Heating Menu.
4.5 Boiler & Pump Enable/Disable
The boiler and pump can be enable/disabled via terminals TA and 9 terminal block Y2 in the
Input/Output box. The function of terminals Y2 TA/9 is configured as follows:
1. Remove jumper from terminals 9 and TA.
OMM-0159_A_A • 6/28/2022 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Page 36 of 83