Ufly Controller and BCM for Modulex EXT
CHAPTER 4: UFLY SETUP AND PROGRAMMING
4.1.3 Viewing the Boiler Setpoint
The setpoint temperature setting is viewed in the Heating Menu.
1. Access the heating menu from the Home Screen or from Main Menu.
Home Screen
If there is more than one heating circuit in the system:
ch13
ch 13
ch ....
4.2 Constant Set Point Mode
When a fixed header temperature is desired, configure the Constant Set Point Mode as shown
below. Follow these instructions to configure the controller for operation in the Indoor/Outdoor
Reset mode.
1. Access the heating menu from the Home Screen or from Main Menu.
Home Screen
2. If there is more than one heating circuit in the system, select the one to be setup
for constant setpoint.
OMM-0159_A_A • 6/28/2022
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Menu
Main Menu
Menu
Main Menu
Page 28 of 83