enphase ENV-S-WM-230 Installation And Operation Manual page 26

View Cellular Connection Information
When the IQ Gateway is using the Mobile Connect modem to connect with Enlighten, select > to
view Cellular Configuration information.
View or Change Ethernet Settings
When the Envoy is using Ethernet to connect with Enlighten, select > to view Ethernet configuration
information. From here you can set up for static IP or reset the IP address, if needed.
WARNING: Do not change the Envoy DHCP setting to use a static IP address unless
you also reserve the same IP address on the broadband router. See the section on
DHCP reservations in the router instructions. Failure to reserve the static IP address on
the router may result in duplicate IP addresses and intermittent Internet connection
problems with the Envoy.
•
To use a static IP address, select Use Static IP and enter information as needed.
•
Select Update. The application asks you to confirm:
This may interrupt communications with the IQ Gateway and require you to reconnect.
•
Select OK to continue or select Cancel.
26 © 2022 Enphase Energy Inc. All rights reserved.
IQ Gateway-M Installation and
Operation
141-00031 Rev 02