Selecting The Output Laser Enable Mode; Setting The Orientation Of The Text On The Card Edge Display - evertz VistaLINK 7700 MultiFrame Manual

7700 MultiFrame Manual
7707OO-2-OC Telecom and Datacom Optical Wavelength Converter
CTRL
RATE
DCOM
FC-2125MBPS
FC-1062MBPS
FC-531MBPS
FC-266MBPS
FC-133MBPS
ETH-125MBPS
XAUI-3125MBPS
XAUI-3187MBPS
ESCON-200MBPS
BYP

4.2.8. Selecting the Output Laser Enable Mode

In some applications, it is beneficial to disable the laser output with no input signal present. Alternatively, it
may be preferable to maintain an optical output signal, even with no input. The 7707OO-2-OC supports
both modes of operation.
To configure the laser enable mode, select the CTRL menu item in the first menu level. Use the toggle
switch to select the LASR menu item and press the pushbutton. Then use the toggle switch to select either
the LINE side laser or the equipment (EQUP) side laser and press the pushbutton. The toggle switch can
then be used to change the mode of operation. Press the pushbutton to apply the displayed selection and
return to the first menu level. For the sake of brevity, only the LINE side laser will be discussed in the
manual.
CTRL
LASR
LINE
CONT
DISC

4.2.9. Setting the Orientation of the Text on the Card Edge Display

The DISP option allows the user to set a horizontal or vertical orientation for the card edge display. To set
the display orientation, select the CTRL menu item in the first menu level, then use the toggle switch to
show the DISP menu selection and use the pushbutton to select it. Use the toggle switch to change
between HORZ and VERT. Press the push button to make your selection.
CTRL
DISP
HORZ
VERT
Page-14
Fiber Channel, 2.125 Gb/s
FC-2125MBPS
Fiber Channel, 1.062 Gb/s
FC-1062MBPS
Fiber Channel, 531 Mb/s
FC-531MBPS
Fiber Channel, 266 Mb/s
FC-266MBPS
Fiber Channel, 133 Mb/s
FC-133MBPS
Fast Ethernet
ETH-125MBPS
XAUI 3.125 Gb/s
XAUI-3125MBPS
XAUI 3.187 Mb/s
XAUI-3187MBPS
ESCON
ESCON-200MBPS
Reclocker is bypassed
BYP
Continuous operation. Laser is always enabled, even without an
CONT
active input signal.
Discontinuous operation. Laser is disabled when no active input
DISC
signal is detected.
Horizontal display used when the module is housed in the one-rack
HORZ
unit 7701FR frame or the stand-alone enclosure.
Vertical display used when the module is housed in the three-rack
VERT
unit 7700FR frame.
Revision 1.3