Table of Contents
Advertisement
WARNING:
Disconnect tool from its power source before actuator removal or installation. Severe personal injury may occur if
power source is not disconnected.
CAUTION:
Actuator assembly-air (704130) can break if not careful.
CAUTION:
Do not over tighten actuator assembly-air (704130). Snug tighten only.
REMOVING ACTUATOR ASSEMBLY-AIR (704130)
1.
Remove lever assembly (724017) including spring pin (A-1174).
2.
With lever assembly (724017) removed, insert a 5/8" open end box wrench around actuator
assembly-air (704130).
3.
Loosen the actuator assembly-air (704130).
4.
Remove wrench. Unthread and remove the actuator assembly-air (704130) with fingers from
the manifold head assembly (744306).
INSTALLING ACTUATOR ASSEMBLY-AIR (704130)
1.
Apply Teflon® tape onto threads of actuator assembly-air (704130) one to two wraps.
2.
Thread the actuator assembly-air (704130) all the way into manifold head assembly (744306) with
fingers.
3.
Insert and turn 5/8" open end box wrench and snug tight approximately 1/4-1/2 turn.
4.
Re-attach the lever assembly (724017) including spring pin (A-1174).
GB752SVSRVT-5 INSTALLATION TOOL
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
ACTUATOR ASSEMBLY-AIR
Image may not
reflect actual tool.
S/N: 1001 AND ABOVE
OVERHAUL
15
REV 5/22
Advertisement
Table of Contents
