Removal And Cleaning Of The Collet On The Q Profi Handpiece; Removal And Cleaning Of The Collet Chuck On The Q Premium Handpiece - Schick Q3 Series Instructions Manual

Hide thumbs Also See for Q3 Series:

Table of Contents

and jerk the collet chuck out, if necessary by knocking on the collet wrench, anti-

clockwise

4. Remove the collet chuck from the shaft

Removal and cleaning of the collet on the Q Profi handpiece

1. Remove the tool, unscrew the tip and pull the dust cap off the handpiece

2. Unscrew and remove the motor cable

3. Insert the chuck key (Article no. 4115) into the open collet chuck, counterhold the

chuck on the opposite side on the shaft with the open-ended wrench (item no. 6223)

and jerk the collet chuck out with a sudden movement or by knocking on the collet

key, if necessary.

4. Remove the collet chuck from the shaft

1. Remove the tool and unscrew the tip

2. Insert the chuck key (Article no. 4115) into the open collet chuck, hold in place on the

wrench grip surface of the shaft with the open-ended spanner (Article no. 9188) and

Issue Q3

Care and control tasks for operators 11

Table of Contents

Q3 basicQ3 profiQ3 premium10785 10775 10765