0
4.4 Characteristics of the tools
Only tools with perfect concentricity may be used. The shaft diameter may be 2.35 mm or
3 mm, depending on the collet chuck variant.
4.5 Type label
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(9)
(10)
5
Transport and storage
5.1 Transport
If external damage to the packaging is visible upon delivery of the goods, this must be im-
mediately communicated to the carrier and confirmed in writing. The damage must then
be immediately reported to Schick GmbH.
Installation site requirements
Very cold appliances must be brought to room temperature before commissioning. Dan-
ger of condensation.
1st Manufacturer
2nd Type
3rd Serial number
4th Power supply
5th Output
6th Mains frequency
7th Order/article no.
8th Pictogram: Disposal information
(8)
9th Pictogram: Observe the operating manual
10th CE marking
D21775 issue Q3