Installing The Control Unit On The Mounting Bracket - Schick Q3 Series Instructions Manual

6 Installation and commissioning
 The mounting bracket is provided with spacers, which serve as a stop for correct
positioning of the knee control unit.
 To do so, position the mounting bracket on the worktable as shown in the fig-
ure and fasten with the screws provided. After assembly, simply break off the
spacers on the mounting bracket.

Installing the control unit on the mounting bracket

 To mount the knee control device, place the recessed backside on the mounting
bracket and push it backwards until you can feel it latch in.
The Q3 hanging rail is identical to the hanging rail of the Q Basic, Q Profi,
QUBE and QUBE II. Accordingly, the Q3 knee device can be attached to the
workplace without any modification work if one of the devices mentioned was
previously attached there.
D21775 issue Q3