Specifications - Renesas Compact Emulator M34571T2-CPE User Manual

M34571T2-CPE User's Manual

1.3 Specifications

Table 1.6 lists specifications of the M34571T2-CPE.
Table 1.6 M34571T2-CPE specifications
Applicable MCUs
Evaluation MCU
Maximum operating frequency
Applicable power supply
Basic debugging functions
Real-time trace function
Hardware break function
Time measurement
Coverage
Connection to user system
(see "2.8 Connecting the User
System" on page 31)
Power supply for emulator
Host machine interface
* Available to connect the host machine that supports USB 2.0. With the USB interface, not all hardware (such as host
machine, USB devices, USB hub) combination will work and guaranteed.
REJ10J0972-0100 Rev.1.00 February 10, 2006
4571 Group
M34571GDFP (mounted in the socket of the emulator)
3.0 V
Set the MCU power supply voltage selection switch
(SW1) to 3V.
5.0 V
Set the MCU power supply voltage selection switch
(SW1) to 5V.
3.0 V ±5 % or 5.0 V ±5 %
- The power supply can be selected by a switch on the M34571T2-CPEB
- Available only from the emulator, not from the user system
- Download
- Software break (max. 8 points, break after execution)
- Program execution/stop (allows free-run execution supporting software breaks)
- Memory reference/setting
- Register reference/setting
- Disassemble display
Recording cycle 32768 cycles
Trace point - 2 address points (range/pass count can be set)
- 1 external trigger point
Trace mode - Before Break mode (Records 32768 cycles before program stops)
- Before Trace mode (Records 32768 cycles before event on)
- About Trace mode (Records 32768 cycles before/after event on)
- After Trace mode (Records 32768 cycles after event on)
Hardware break - 2 address points (range/pass count can be set)
point - 1 external trigger point
Break mode - Address break or trigger break
- Stack over/under flow
- Trace event
- Break at end of trace
- Timer
Time measurement point: 2 address point designation (range can be set)
Resolution: 100 ns
Measurement interval: 8 types
Count source: Emulator timer or MCU cycle
C0 coverage
For 26-pin 2.54-mm-pitch DIP
26-wire normal-pitch cable (included)
DC 5.0 V ±5 %/2 A externally supplied (Prepare a power supply separately.)
USB (USB 1.1 full-speed, mini-B standard connector)
1. Outline
Divided-by 8-mode
6.0 MHz
Divided-by 4-mode
Divided-by 2-mode
Through mode 4.4 MHz
Divided-by 8-mode
Divided-by 4-mode
6.0 MHz
Divided-by 2-mode
Through mode
Page 18 of 72