Changing Settings; Changing The Power Supply Voltage To The Mcu - Renesas Compact Emulator M34571T2-CPE User Manual

M34571T2-CPE User's Manual

2.9 Changing Settings

2.9.1 Changing the Power Supply Voltage to the MCU

As shown in Table 2.6 below, set the switch according to the connection to the user system.
Table 2.6 Setting switch
MCU power supply voltage
selection switch (SW1)
3 V
5 V
Note on Jumper Switch Settings:
Always shut OFF the emulator before changing the setting of the jumper switches, and connecting the cable.
Otherwise the internal circuit may cause a break.
REJ10J0972-0100 Rev.1.00 February 10, 2006
Supplied from the emulator. The MCU operating voltage is 3 V.
Supplied from the emulator. The MCU operating voltage is 5 V.
CAUTION
Description
2. Setup
Page 34 of 72