Foley United 633 Operator's Manual page 38

GRINDING OTHER REELS
PLACING A CUTTING UNIT NOT LISTED ON THE ACCU-REEL POSITIONER.
FIG. 37
If the cutting unit is not listed on the decal on the left side of the ACCU-REEL POSITIONER you will need to
use the POSITION LOCK on the right side of the ACCU-REEL POSITIONER.
INSTALL CUTTING UNIT
1. Pull up on the pin and turn it 90° to lock it in the UP position.
2. Move the right side knob to point at the desired number. See FIG. 37.
3. Move the cutting unit to the approximate grinding position by placing the rear roller into the V-blocks on
the ACCU-REEL POSITIONER. Move ACCU-REEL POSITIONER with the cutting unit forwards or backwards
until the center shaft of the reel is positioned at a one o'clock, or 30° angle, (looking from the right side)
relative to the shaft of the GRINDING HEAD. See FIG. 38.
MAKE SURE THE GRINDING WHEEL IS LOW ENOUGH TO CLEAR THE REEL. YOU CAN LOWER THE
GRINDING WHEEL BY PRESSING THE OUTFEED BUTTON.
FRONT TOOLING
Place the rear roller of the cutting unit into the V-Blocks on the ACCU-REEL POSITIONER ensuring the
FRONT HEIGHT ADJUSTER is in a position to receive the front roller. Clamp the rear roller and continue with
the setup process as shown on Page 22.
FRONT ROLLER
CLAMP
V-BLOCKS
38
REEL
FIG. 38
REAR ROLLER CLAMP
ORIGINAL INSTRUCTIONS
REAR ROLLER
SPIN
STONE
T-HANDLE
LOCK KNOB