Foley United 633 Operator's Manual page 30

OPERATION
TRAVERSE SPEED KNOB
END OF REEL
FIG. 29
NOTE: Grinding wheel must be positioned off of the
reel (if frame allows).
SET TRAVEL LIMITS
Set the TRAVEL LIMITS of the grinding head by either
manually moving the grinding carriage or pressing the
TRAVERSE SWITCH to ON and turning up the TRAVERSE
SPEED KNOB.
1. Move the TRAVEL LIMIT SENSORS out to allow the
2. Move the GRINDING CARRIAGE until the grinding
3. When the GRINDING CARRIAGE is in position,
TRAVERSE SWITCH
4. Test the TRAVEL LIMIT SENSORS by moving the
5. Repeat the process on the opposite TRAVEL LIMIT
WHEEL
30
grinding wheel to travel past the ends of the reel.
wheel has cleared the end of the reel (if clearance
to the frame allows) (see FIG. 29).
move the TRAVEL LIMIT SENSORS in until the light
on the SENSOR illuminates.
GRINDING CARRIAGE in a couple of inches and
then back out to verify that the sensor properly
stops the carriage.
SENSOR.
TRAVEL LIMIT SENSOR
ORIGINAL INSTRUCTIONS