Horizontal Positioning - Foley United 633 Operator's Manual

OPERATION
4. Press the RESET/CHECK BUTTON again to take the first reading on the left side. The BLUE LED and RED
LED will flash once.
5. Retract the GAUGE PIN and move the GRINDING CARRIAGE to the right until the decal on the ACCU-
POSITIONING GAUGE aligns with the decal on the TOOLING BAR. (see FIG.21).
Release the TAB and allow the GAUGE PIN to travel up to the the center shaft of the cutting unit.
NOTE: It is important to NOT move the gauge forward or back, if this occurs your readings will be skewed.
6. Press the RESET/CHECK BUTTON to take the second reading. The BLUE LED and RED LED will blink twice
and then either the BLUE or the RED LED will continue to flash to indicate which direction to turn the
GREY HANDWHEEL: BLUE for COUNTER-CLOCKWISE and RED for CLOCKWISE.
7. Use the GREY HAND-WHEEL to adjust the CARRIAGE vertically until the GREEN LED illuminates. Your
final VERTICAL ADJUSTMENT on the CROSS-SLIDE ASSEMBLY should always be COUNTER-CLOCKWISE.
8. At this point you can choose to recheck the adjustment by retracting the GAUGE PIN and moving back
to the right side. Release the TAB and allow the GAUGE PIN to travel up to the the center shaft of the
cutting unit. If the LED is still GREEN, then proceed with the HORIZONTAL POSITIONING. If not, repeat
the entire VERTICAL POSITIONING process.
FIG. 21

HORIZONTAL POSITIONING

Indicates "Turn the ORANGE HAND-WHEEL clockwise" to move the right side of
the GRINDING CARRIAGE towards the operator.
Indicates the GRINDING CARRIAGE is aligned.
Indicates "Turn the ORANGE HAND-WHEEL counter-clockwise" to move the
right side of the GRINDING CARRIAGE away from the operator.
RESET/CHECK BUTTON.
ORANGE CROSS SLIDE
26
ORIGINAL INSTRUCTIONS
FIG. 22