Vertical Positioning - Foley United 633 Operator's Manual

OPERATION
POSITION THE GRINDING HEAD CARRIAGE TO THE CUTTING UNIT
Make sure that the ACCU-POSITIONING GAUGE is on the lower pin position and unlock the GREY HANDLE
on the CROSS SLIDE ASSEMBLY.
GAUGING DECAL
FIG. 18
1. Release the TRAVERSE LOCK handle (FIG. 17) and move the GRINDING CARRIAGE to the left side of the
cutting unit until the decal on the ACCU-POSITIONING GAUGE aligns with the decal on the tooling bar
(see FIG. 19). The TRAVERSE LOCK RELEASE ARM is located at the front of the carriage under the TRAVEL
LIMITS BRACKET. Rotate the release arm UP to release and DOWN to engage (see FIG. 17).
2. Press the RELEASE TAB and allow the GAUGE PIN to travel to the center of the cutting unit shaft.
3. Press the RESET/CHECK BUTTON and hold for three seconds to reset the ACCU-POSITIONING GAUGE to
zero on the fixed side of the traverse base. All three LEDs will blink twice to indicate that the GAUGE is reset.

VERTICAL POSITIONING

LED INDICATORS
Indicates "Turn GREY HAND-WHEEL clockwise" to lower
the right side of the GRINDING CARRIAGE.
Indicates that the GRINDING CARRIAGE is aligned.
Indicates "Turn the GREY HAND-WHEEL counter-clockwise"
to raise the right side of the GRINDING CARRIAGE.
RESET/CHECK button.
GAUGING STEPS
Step 1-Press and hold the RESET button for 3 seconds.
Step 2-Move the grinding head to the left side of the
cutting unit, gauge, then press the CHECK button.
Step 3-Move the grinding head to the right side of the
cutting unit, gauge, then press the CHECK button.
The green LED lit indicates the cutting unit is aligned.
Press the RESET button after the GRINDING CARRIAGE is
aligned to reset the ACCU-POSITIONING GAUGE.
25
ORIGINAL INSTRUCTIONS
GREY HANDWHEEL
FIG. 17
FIG. 19
FIG. 20