Foley United 633 Operator's Manual page 27

OPERATION
1. Move the ACCU-POSITIONING GAUGE to the UPPER PIN for HORIZONTAL POSITIONING.
2. Unlock the ORANGE HANDLE on the CROSS SLIDE ASSEMBLY.
3. Release the TRAVERSE LOCK HANDLE (see FIG. 15) and move the GRINDING CARRIAGE to the left side of
the cutting unit (see FIG. 23) until the decal on the ACCU-POSITIONING GAUGE aligns with the decal on
the tooling bar (see FIG. 19).
4. Press the RELEASE TAB and allow the GAUGE PIN to travel up to the center of the cutting unit shaft.
5. Press the RESET/CHECK and hold until all three LEDs blink twice to reset the ACCU-POSITIONING GAUGE
to zero.
6. Press the RESET/CHECK BUTTON again to take the first reading on the left side. The RED and BLUE LEDs
will flash once.
7. Retract the GAUGE and move the GRINDING CARRIAGE to the right side of the cutting unit (see FIG. 24)
until the decal on the ACCU-POSITIONING GAUGE aligns with the decal on the tooling bar (see FIG. 19).
8. Release the tab and allow the GAUGE PIN to travel up to the the center shaft of the cutting unit. NOTE: It
is important to NOT move the gauge forward or back, if this occurs your readings will be skewed.
9. Press the RESET/CHECK button to take the right side reading. The RED and BLUE LEDs will flash twice and
then either the BLUE or the RED LED will continue to flash to indicate which direction to turn the GREY
HANDWHEEL: BLUE for COUNTER-CLOCKWISE and RED for CLOCKWISE.
10. Use the ORANGE HAND-WHEEL to adjust the GRINDING CARRIAGE until the green LED illuminates.
NOTE: If you wish to recheck the positioning, retract the GAUGE PIN and move the head back to the left.
Release the TAB and allow the GAUGE PIN to travel up to the reel shaft. If the LED is green, the positioning
is complete. If not, reset the gauge and redo the entire gauging process.
11. Remove and store the ACCU-POSITIONING GAUGE (see FIG. 25) and verify that all lock handles are tight.
Your reel is now ready for SPIN grinding
REMOVE AND STORE ACCU-POSITIONING GAUGE
FIG. 23
ACCU-POSITIONING GAUGE STORAGE
FIRMLY HAND-TIGHTEN ALL LOCKING KNOBS BEFORE
GRINDING. ANY LOOSENESS WILL ADVERSELY
AFFECT GRINDING QUALITY.
27
ORIGINAL INSTRUCTIONS
FIG. 24
FIG. 25