Operation - Foley United 633 Operator's Manual

OPERATION

PREPARE CUTTING UNIT FOR SHARPENING
1. Follow the cutting unit manufacturers' recommendations for proper maintenance when preparing the
cutting unit for sharpening.
2. The reel to be sharpened should be thoroughly cleaned.
3. If possible, remove the wheels and bed bar.
4. Inspect, adjust and/or replace any worn or damaged bearings. Make sure reel bearings are adjusted
properly so the reel turns easily by hand. Because this grinder mounts the reel using the rear roller and
front roller if applicable, the bearings must be in good repair with no freeplay. The front and rear rollers
must be properly aligned parallel to the reel prior to grinding.
ACCU-REEL POSITIONER
Place the ACCU-REEL POSITIONER to the correct position based on manufacturer and reel diameter. Set
your relief angle to the pre-set angle using the RELIEF ANGLE ADJUSTER. NOTE: The pre-positioned settings
do not work for walking greens mowers with a rear drum only. SEE PAGE 38. To move the ACCU-REEL
POSITIONER, pull up on the LOCK PIN and move the assembly to the desired position. To lock the assembly,
release the pin and move the assembly until it locks into position. To move the RELIEF ANGLE POSITIONER,
turn the RELIEF ANGLE ADJUSTER knob left or right until you reach the desired RELIEF ANGLE.
Selecting a 7" reel then change RELIEF ANGLE ADJUSTER to the corresponding 12° angle relief angle
Example: If your reel is a 7" Jacobsen reel you will set the ACCU-REEL POSITIONER as shown above and
the relief will be set to the corresponding 12° angle as shown in the picture to the right. If the reel you are
grinding does not fit these parameters see Page 38.
STEP 1: PLACING THE CUTTING UNIT
Switch on the machine by pressing the
POWER WITCH on the side panel. Pull out
the E-STOP BUTTON and press the START/
RESET BUTTON.
RELIEF ANGLE DECAL
18
ORIGINAL INSTRUCTIONS
RELIEF ANGLE
ADJUSTER