Foley United 633 Operator's Manual page 22

OPERATION
FRONT TOOLING
1. Place the rear roller of the cutting unit into the V-BLOCKS (as shown above) on the ACCU-REEL
POSITIONER. It may be necessary to move the FRONT HEIGHT ADJUSTER into a position to receive the
front roller. This is done by unlocking the LOCK HANDLE and sliding the FRONT HEIGHT ADJUSTER in or
out in order for the front roller of the cutting unit to be placed on the FRONT HEIGHT ADJUSTER.
2. When the front and rear rollers are in position, clamp the rear roller with the REAR ROLLER CLAMP. The
REAR ROLLER CLAMP rotates 90° (by turning the T-Handle) when placed on the ACCU-REEL POSITIONER.
Once placed, lock the LOCK KNOB by pushing down towards the table.
FIG. 9
1. Place the ACCU-POSITIONING GAUGE on the lower
pin on the right side of the grinding head. See FIG. 9.
2. Adjust the ACCU-POSITIONING GAUGE so the pin of
the GAUGE meets the center shaft of the cutting unit.
This is done by releasing the TAB (see FIG. 10) and
allowing the pin to travel to the center of the cutting
unit shaft while rotating the ACCU-POSITIONING
GAUGE front and back until it aligns with the center
shaft of the cutting unit.
3. Secure in place with the LOCK HANDLE.
4. Lower the GAUGE PIN back into the TAB.
STEP 1: PLACE THE CUTTING UNIT
V-BLOCKS
SET THE HEIGHT
REAR ROLLER CLAMP
IF NECESSARY- Lower the grinding head
to avoid contact between the reel and
grinding head.
LOWER PIN
REEL STOP
LOCK
HANDLE
22
ORIGINAL INSTRUCTIONS
T-HANDLE
LOCK KNOB
GAUGE
PIN
FIG. 10
TAB