Foley United 633 Operator's Manual page 23

OPERATION
SET HEIGHT OF THE REEL
REEL STOP
FIG. 11
LOWEST BLADE OF CUTTING UNIT
1. Place the round REEL STOP on top of the shaft on the ACCU-POSITIONING GAUGE.
2. Press the TAB on the right side of the ACCU-POSITIONING GAUGE to release the GAUGE PIN and allow
the STOP to travel up to the lowest reel blade on the cutting unit. See FIG 11.
3. Unlock the LOCK HANDLE on the left side of the HEIGHT ADJUSTER (see FIG. 12).
4. Select the DIRECTIONAL PIN setting on the ratchet (see FIG. 12).
5. Adjust the HEIGHT ADJUSTER up or down until the the decal on the ACCU-POSITIONING GAUGE aligns
with the GAUGE PIN HANDLE on the ACCU-POSITIONING GAUGE (see FIG. 12).
6. Re-lock the LOCK HANDLE on the HEIGHT ADJUSTER (see FIG. 12).
CLAMP FRONT ROLLER REMOVE AND STORE
FIG. 13
VERIFY ALL CLAMPS AND LOCK
HANDLES ARE TIGHT
7. Clamp the front roller (see FIG. 13).
8. Retract the GAUGE PIN into the locking TAB.
9. Remove and store the REEL STOP on the side of the ACCU-POSITIONING GAUGE (see FIG. 13).
NOTE: The FRONT CLAMP and FRONT TOOLING may need to be adjusted in or out in order to avoid
interference with the grinding head. The FRONT TOOLING slides in or out by unlocking the LOCK HANDLE and
pushing or pulling on it.
STOP BLOCK
LOCK
HANDLE
FIG. 12
HEIGHT ADJUSTER
FIG. 14
FRONT ROLLER CLAMP
23
ORIGINAL INSTRUCTIONS
DECAL
DIRECTIONAL PIN