Advertisement
Step 41: Attach TNR 3 Slide to Fort
A: On the fourth attached Elbow Assembly remove the pan bolt and nut which is facing the fort (installed in Step 32).
(fig. 41.1) The bolt will no longer be needed, but keep the lock nut.
B: Loosely attach TNR3 Tube Support (at the slightly bent end) to the slide seam using 1 (PB6) 1/4 x 1" Pan Bolt (with
flat washer and the previously removed lock nut). (fig. 41.2)
C: Rotate TNR3 Tube Support and attach to (9266) Folding Panel Assembly Right B using 1 (S6) #12 x 1" Pan Screw
as shown in (fig. 41.2).
D: Fully tighten screw and bolt.
Fig. 41.1
europecustomerservice@kidkraft.com
+31 20 305 8620
M-F from 09:00 to 17:30 (GMT+1)
Note: Flat
end down
9266
Hardware
1 x
#12 x 1" Pan Screw
S6
1 x
1/4 x 1" Pan Bolt
PB6
(1/4" flat washer & 1/4" lock nut - previously removed)
parts.kidkraft.eu
77
TNR 3 Tube
Support
Fig. 41.2
Remove PB1 (1/4 x 3/4" Pan Bolt)
S6
first then install PB6 (1/4 x 1" Pan
Bolt with flat washer)
Lock
Nut
Flat
Washer
PB6
Other Parts
1 x TNR3 Tube Support
Advertisement
