Advertisement
Step 25: Roof Support Assembly
Part 1
A: Place (9501) Top Swing flat on the ground with the angles facing up. The sharper angle should be on the right
end. Place (9503) Roof Support as shown in fig. 25.1 making sure that it's flush with the edge of (9501) Top Swing.
B: Place (9502) Support Upright as shown in fig. 25.1, making sure that it's flush with the end of (9503) Roof
Support and centered over the pre-drilled holes in (9501) Top Swing. Check to ensure that the assembly is square
then attach boards using 4 (S4) #8 x 3" Wood Screws.
C: Repeat steps A and B to create a second assembly.
Fig. 25.1
Wood Parts
2 x
Top Swing 1 x 2 x 56 7/16"
9501
2 x
Support Upright 1 x 2 x 10 5/8"
9502
2 x
Roof Support 1 x 2 x 34 1/16"
9503
europecustomerservice@kidkraft.com
+31 20 305 8620
M-F from 09:00 to 17:30 (GMT+1)
S4
Flush
9502
S4
8 x
S4
parts.kidkraft.eu
9503
9501
Hardware
#8 x 3" Wood Screw
57
S4
Flush
Advertisement
