Advertisement
Step 33: Attach Flange Assembly to Fort
A: With a helper place the Flange Assembly in the opening so that it's flush to the (9514) Mid Cross as shown
in fig. 33.1 & 33.2. Pre-drill 1/8" pilot holes in the bottom 4 mounting locations (approximate spots where circles
are on figure), making sure the pre-drilled holes are a minimum of 2.5 cm (1") deep. (fig. 33.1)
B: Attach Flange Assembly to bottom of opening using 4 (S7) #12 x 2" Pan Screws in the pre-drilled holes. (fig.
33.1) Make sure the flat surfaces of the Flange Assembly are flush to the (9514) Mid Cross as shown in fig.
33.3.
C: Attach the Flange Assembly flush to top of (9514) Mid Cross opening using 4 (S6) #12 x 1" Pan Screws as
shown in fig. 33.1 and to both sides using 5 (S6) #12 x 1" Pan Screws per side. (fig. 33.1)
Fig. 33.1
Inside View
side
S7
europecustomerservice@kidkraft.com
+31 20 305 8620
M-F from 09:00 to 17:30 (GMT+1)
9514
S6
* take inside view
from an existing
instruction
the 4 holes need
to be pre-drilled
14 x
4 x
side
S6
x 5
per
side
Hardware
#12 x 1" Pan Screw
S6
#12 x 2" Pan Screw
S7
parts.kidkraft.eu
69
Fig. 33.2
Outside View
9514
flush to top of
the (9514) Mid
Cross
Fig. 33.3
flush to bottom
* take inside view
from an existing
instruction
Advertisement
