Table of Contents
Advertisement
I N S T A L L A T I O N
FLAMMABLE MATERIAL WARNING
Keep fixture minimum 5.0 feet (1.5m) away from flammable materials and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
MINIMUM DISTANCE TO OBJECTS/SURFACES IS 6.6 FEET (2 METERS).
MINIMUM DISTANCE OF FLAMMABLE MATERIALS FROM THE SURFACE IS 1.6
FEET (0.5 METER)
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
•
Fixture MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations.
•
Before rigging/mounting a single fixture or multiple fixtures to any metal truss/structure or plac-
ing the fixture(s) on any surface, a professional equipment installer MUST be consulted to deter-
mine whether the metal truss/structure or surface is properly certified to safely hold the combined
weight of the fixture(s), clamps, cables, and accessories.
Maximum fixture ambient operating temperature is 113°F (45°C). Do not use operate the fixture
•
when ambient temperature exceeds this value!
•
Fixture(s) should be installed outside walking paths, seating areas, or areas were unauthorized
personnel might reach the fixture by hand.
•
NEVER stand directly below the fixture(s) when rigging, removing, or servicing.
•
Overhead fixture installation must always be secured with a secondary safety attachment, such as
an appropriately rated safety cable.
•
Allow approximately 60 minutes for the fixture to cool down before servicing.
IP RATING
An IP rated lighting fixture is commonly installed in outdoor environments and has been designed
with an enclosure that effectively protects the ingress (entry) of external foreign objects such as dust
and water. The Ingress Protection (IP) rating system is commonly expressed as "IP" followed by two
numbers (i.e. IP65), where the numbers define the degree of protection. The first digit (Foreign Bodies
Protection) indicates the extent of protection against particles entering the fixture, while the second
digit (Water Protection) indicates the extent of protection against water entering the fixture.
An IP65 rated lighting fixture, such as this one, is dust tight, and protected against low pres-
sure water jets from any direction.
RIGGING
Overhead rigging requires extensive experience, including calculating working load limits,
knowledge about installation materials being used, and periodic safety inspection of all instal-
lation material and the fixture, among other skills. If you lack these qualifications, do not
attempt the installation yourself. Improper installation can result in bodily injury.
9
Advertisement
Table of Contents
